de
en
Benefits
- Extremely safe – avoidance of incorrect loading through optimum alignment of the bolt-on swivel in the load direction – even when subjected to tensile load
- Additionally tested safety: DGUV-certified with H-stamp
Technical data
Standard
EN 1677-1Type of attachment
multi-legAttachment
Screw-inTilting
180°Load angle
± 90°Range of application Attachment devices
Attachment technologySafety factor
4Rotation
360° (under load)Operating temperature
Identification mark
Batch numberQuality grade
8Certification
H-stampDimensions
Options
Option thread
Option Identification mark
Options on request
in special designsHandling
1.Bolt-on swivel must be tightened so that it is fully contacting the support surface. Then check that the upper part rotates freely and easily.
2.Do not use an extension.
3.Do not exceed the tightening torques specified in the product table (values specified are maximum values)!
4.For the installation it is sufficient to tighten the bolt-on swivel manually using a suitable tool (e.g. open-ended spanner conforming to DIN 895 or DIN 894).
CAD
Planning
-
Dimensions
Dimensions
-
CAD
CAD
Planning
Benefits
- Extremely safe – avoidance of incorrect loading through optimum alignment of the bolt-on swivel in the load direction – even when subjected to tensile load
- Additionally tested safety: DGUV-certified with H-stamp
Technical data
Standard
EN 1677-1Type of attachment
multi-legAttachment
Screw-inTilting
180°Load angle
± 90°Range of application Attachment devices
Attachment technologySafety factor
4Rotation
360° (under load)Operating temperature
Identification mark
Batch numberQuality grade
8Certification
H-stampDimensions
Options
Option thread
Option Identification mark
Options on request
in special designsHandling
1.Bolt-on swivel must be tightened so that it is fully contacting the support surface. Then check that the upper part rotates freely and easily.
2.Do not use an extension.
3.Do not exceed the tightening torques specified in the product table (values specified are maximum values)!
4.For the installation it is sufficient to tighten the bolt-on swivel manually using a suitable tool (e.g. open-ended spanner conforming to DIN 895 or DIN 894).
CAD
Planning
-
Dimensions
Dimensions
-
CAD
CAD
Planning