de
en
Benefits
- Extremely safe – avoidance of incorrect loading through optimum alignment of the eyebolt in the load direction – even when subjected to tensile load
- Additionally tested safety: German Social Accident Insurance (DGUV)-certified with H-stamp
- Suitable for continuous rotary movements
Technical data
Quality grade
10Operating temperature
Standard
EN 1677-1Certification
H-stampMarking
Batch numberAttachment
Screw-inSafety factor
4Rotation
360° (under load)Tilting
rigidRange of application Attachment devices
Attachment technologyType of attachment
multi-legDimensions
Options
Option Identification mark
Safety instructions
Handling
1.For the installation it is sufficient to tighten the bolt-on swivel manually using a suitable tool (e.g. open-ended spanner conforming to DIN 895 or DIN 894).
2.Eye bolt must be tightened so that it is fully contacting the support surface. Then check that the upper part rotates freely and easily.
3.Do not use an extension.
4.Straight pull with continuous rotary movement under load in single-leg suspension gear at 0°.
5.Do not exceed the tightening torques specified in the product table (values specified are maximum values)!
CAD
Planning
-
Dimensions
Dimensions
-
Safety instructions
Safety instructions
-
CAD
CAD
Planning
Benefits
- Extremely safe – avoidance of incorrect loading through optimum alignment of the eyebolt in the load direction – even when subjected to tensile load
- Additionally tested safety: German Social Accident Insurance (DGUV)-certified with H-stamp
- Suitable for continuous rotary movements
Technical data
Quality grade
10Operating temperature
Standard
EN 1677-1Certification
H-stampMarking
Batch numberAttachment
Screw-inSafety factor
4Rotation
360° (under load)Tilting
rigidRange of application Attachment devices
Attachment technologyType of attachment
multi-legDimensions
Options
Option Identification mark
Safety instructions
Handling
1.For the installation it is sufficient to tighten the bolt-on swivel manually using a suitable tool (e.g. open-ended spanner conforming to DIN 895 or DIN 894).
2.Eye bolt must be tightened so that it is fully contacting the support surface. Then check that the upper part rotates freely and easily.
3.Do not use an extension.
4.Straight pull with continuous rotary movement under load in single-leg suspension gear at 0°.
5.Do not exceed the tightening torques specified in the product table (values specified are maximum values)!
CAD
Planning
-
Dimensions
Dimensions
-
Safety instructions
Safety instructions
-
CAD
CAD
Planning