de
en
Benefits
- Additionally tested safety: German Social Accident Insurance (DGUV)-certified with H-stamp
- Extremely safe – avoidance of incorrect loading through optimum alignment of the bolt-on swivel in the load direction – even when subjected to tensile load
Technical data
Quality grade
8Operating temperature
Standard
EN 1677-1Certification
H-stampIdentification mark
Batch numberAttachment
Screw-inSafety factor
4Rotation
360° (under load)Tilting
180°Load angle
± 110°Range of application Attachment devices
Attachment technologyType of attachment
multi-legDimensions
Options
Options on request
in special designsOption thread
Option Identification mark
Handling
1.Do not use an extension.
2.Do not exceed the tightening torques specified in the product table (values specified are maximum values)!
3.For the installation it is sufficient to tighten the bolt-on swivel manually using a suitable tool (e.g. open-ended spanner conforming to DIN 895 or DIN 894).
4.Bolt-on swivel must be tightened so that it is fully contacting the support surface. Then check that the upper part rotates freely and easily.
CAD
Planning
-
Dimensions
Dimensions
-
CAD
CAD
Planning
Benefits
- Additionally tested safety: German Social Accident Insurance (DGUV)-certified with H-stamp
- Extremely safe – avoidance of incorrect loading through optimum alignment of the bolt-on swivel in the load direction – even when subjected to tensile load
Technical data
Quality grade
8Operating temperature
Standard
EN 1677-1Certification
H-stampIdentification mark
Batch numberAttachment
Screw-inSafety factor
4Rotation
360° (under load)Tilting
180°Load angle
± 110°Range of application Attachment devices
Attachment technologyType of attachment
multi-legDimensions
Options
Options on request
in special designsOption thread
Option Identification mark
Handling
1.Do not use an extension.
2.Do not exceed the tightening torques specified in the product table (values specified are maximum values)!
3.For the installation it is sufficient to tighten the bolt-on swivel manually using a suitable tool (e.g. open-ended spanner conforming to DIN 895 or DIN 894).
4.Bolt-on swivel must be tightened so that it is fully contacting the support surface. Then check that the upper part rotates freely and easily.
CAD
Planning
-
Dimensions
Dimensions
-
CAD
CAD
Planning